The RadioMaster RP series receivers are built-in a TCXO (temperature-compensated crystal oscillator) now, which ensures reliable, stable, and accurate signal reception, allowing for superior performance in demanding environments and enhancing the flight experience.
The RP1 and RP2 2.4GHz ELRS nano series receivers are open-source receivers based on ExpressLRS. The Nano receivers, first developed by Jye Smith from the ExpressLRS development team, feature ESP8285 MCU and SX1280 RF chips. The RP1 has a UFL antenna socket for full-range antenna use. The RP2 has a built-in ceramic antenna which is super light and small in size and ideal for racing.
The RP1 and RP2 feature WIFI built in so you can upgrade firmware by WIFI and configure the Receiver via the built-in WebUI with your PC or mobile phone.
Due to the low-latency and high-refresh-rate RF module, the RP1 and RP2 are ideal for FPV races or Long Range. Suitable for many models due to the ultra-light and Nano size, these receivers can fit just about anywhere!
Features:
Improved PCB design is better for heat dissipation.
LED on the top side of the PCB.
Solder pads are improved and easier to solder to.
Built-in a TCXO (temperature-compensated crystal oscillator)
Compatible with all 2.4GHz ExpressLRS modules and transmitters with built-in 2.4GHz ExpressLRS
Firmware Version: ExpressLRS v2.4 pre-installed
FW Target: RadioMaster RP1/2 2400 RX
Maximum receive refresh rate: 500Hz/F1000Hz
Minimum receiver refresh rate: 25Hz
Package Includes:
1× RP2 ExpressLRS 2.4ghz Nano Receiver
1× User Manual
1× CRSF wire
Specification:-
| Item Type: |
Receiver |
|---|---|
| Frequency(GHz) |
2.4 |
| MCU Type |
EPS8285 |
| Antenna Type: |
On Board SMT Antenna |
| Operating Voltage (V) |
5V |
| Interfaces |
CRSF |
| Length (mm): |
13 |
| Width (mm): |
11 |
| Height (mm): |
7 |
| Weight (g): |
0.55g (On Board antenna) |
| Shipping Weight | 0.01 kg |
| Shipping Dimensions | 11 × 7 × 1 cm |
