Holybro PM07 Power Module (14S)

0NOTE:- We might take 4 to 8 days to ship this product.

This PM07 Power Module supplies clean 5.2V to the flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated ESC power & signal distribution for up to 8 ESCs.

PM07 has two 5.2V power output ports that can provide redundant power to the flight controller, with independent circuits, BEC IC, and circuitry.

It is also great for flight controllers that do not have built-in servo header pins like the Pixhawk 6C & Pixhawk 4. It comes with pre-soldered wires, a capacitor, and an XT60 connector.

Please Note: 

The XT60 Plug and 12AWG wire that are pre-soldered on the board are rated for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to this chart for reference. 
This PM02 Power Module uses analog data output and is not compatible with the Pixhawk 5X & 6X (Requires a digital PM like PM02D).

Features:

Dual Redundant Power: PM07 provides two independent 5.2V power outputs for flight controller redundancy.
Integrated ESC Distribution: Streamlines power and signal distribution for up to 8 ESCs.
Flight Controller Compatibility: Ideal for Pixhawk 6C & Pixhawk 4, lacking built-in servo header pins.
High Current Handling: Supports demanding conditions with 90A continuous and 140A burst current ratings.
Efficient Power Supply: Delivers stable 5.2V for clean power and improved stability.
Pre-soldered Convenience: Comes with pre-soldered wires, capacitor, and XT60 connector for easy installation.

Package Include:

1× PM07 board
1× 80mm XT60 connector wire (installed)
1× Electrolytic capacitor: 220uF 63V (installed)
2× JST GH 10P Cable
1× JST GH 8P Cable
2× JST GH 6P Cable

Specification:-