PM02D provides a regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6-pin cable. The onboard switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 12S (HV). The Power Module comes completely assembled with XT60 connectors, wrapped in shrink tubing for physical damage protection.
It is not designed to power servos, please use your aircraft’s ESC/BEC for that. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact.
Note:
PM02D HV version is supported by PX4. For Ardupilot, it is supported in version 4.4 and later. The full setup guide can be found here.
This PM uses I2C digital signal data output, Compatible with Pixhawk 5X/6X Series.
NOT compatible with a flight controller that uses analog PM such as the Pixhawk 6C & Mini, Pixhawk4 & Mini, pix32 v5, or Durandal flight controllers.
Features:
Regulated Output: 5.2V and 3A max for stable power supply
Battery Compatibility: Supports LiPo batteries up to 12S (HV)
Current Sensing: High-accuracy current sensing up to 327A for HV
Monitoring Interface: I2C compatible interface for voltage and current monitoring
Physical Protection: Wrapped in shrink tubing to prevent damage
Connectors Equipped with XT60 connectors for reliable connections.
Package Includes:
1× Holybro PM02D Power Module High Voltage (2S -12S)
Specification:-
| Item Type: |
Module |
|---|---|
| Input Voltage (V) |
HV: 2S-12S, LV: 2S-6S (Discontinued) |
| Max Current (A) |
HV: 327A, LV: 164A (Discontinued) |
| Output |
5.2V and 3A max |
| Weight (g): |
20 |
| Shipping Weight | 0.04 kg |
| Shipping Dimensions | 16 × 9 × 3 cm |
